User Guide
Bracket Installation
|
Screw Type Bracket
Used when there are two screwholes at the front of the loupes eg Orascoptic TTL loupes. |
1. Remove the faceplate
If there is a faceplate, please remove this to expose the holes at the front of the loupes |
2. Screw in the bracket
Align the screws with the screwholes and gently tighten using the Allen key provided. |
|
U Type Bracket
Used for the majority of TTL loupes when no screwholes exist. |
1. Position the bracket
Place the bracket over the central frame of your loupes |
2. Secure the bracket
Using the Allen key provided, gently tighten the central screw until the bracket is secure. |
|
Flip Up Bracket
Used for the majority of flip up loupes. |
1. Position the bracket
Place the bracket over the central bar of your loupes, with the teeth on the bracket facing upwards |
2. Attach the bracket
The bracket will click into place |
1. Charge the battery
Please fully charge your battery prior to use. The power indicator on the front of the battery indicates charge level. Please note that the initial charge can take several hours. |
2. Attach light to bracket
If the light unit is not already attached to the bracket, please use the Allen key provided. Please note the screw that holds the light must be inserted from the right hand side as shown. |
3. Wire management
Use the spiral wrap or the rubber loops provided to hold the wire against the side of the loupes frame. Run the remaining wire down your back, connect it to the battery, and place the battery in your pocket / on your belt. |
4. Select light intensity
Use the adjustment dial to select light intensity. Most clinicians use around 75% intensity. A lower intensity will result in a longer battery life. |
5. Composite filter (if needed)
Attach the orange composite filter provided to prevent premature curing of resin-based dental materials. |
Cleaning Instructions
The headlight is manufactured using only high-quality components. This is an optical precision instrument that must be cleaned and handled with the greatest care.
- Only use a lens cleaner on the LED unit with a microfibre cloth
- All other components can be cleaned with a disinfectant wipe
- Do not immerse any components into liquid
- Do not use an autoclave, chemiclave, glutaraldehyde, iodophor or any other sterilisation method
Safety Instructions
- Only OriginalOptics power supplies are to be used to power the battery
- Do not look directly into the headlight or aim the headlight directly into someone’s eyes
- The control unit and the battery must be used exclusively for the purpose described
- Under no circumstances should you open the housing of the charger or the control unit. Never take the devices apart or undertake modifications